WEEK 8 REPORT
For this week, there is the explanation why Arduino Uno was choose to be used in this project as microcontroller to process the data.
The figure above show the Arduino uno that has been used in this project
The Arduino Uno is a microcontroller board based on the ATmega328. It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz ceramic resonator, a USB connection, a power jack, an ICSP header, and a reset button.
The Arduino Uno can be powered either by USB or an external power supply. The power source is automatically selected. An AC-to-DC adapter (wall-wart) or a battery can provide external (non-USB) power. A 2.1mm center-positive plug can be plugged into the board's power connector to connect the adapter. Battery leads can be put into the power connector's Gnd and Vin pin headers. The board can be powered from a 6 to 20 volt external supply. If less than 7V is given, the 5V pin may supply fewer than five volts, making the board unstable. The voltage regulator may overheat and destroy the board if more than 12V is used. The voltage range recommended is 7 to 12 volts.
A computer, another Arduino, or other microcontrollers can all be communicated with using the Arduino Uno. On digital pins 0 (RX) and 1 (TX), the ATmega328 supports UART TTL (5V) serial connection (TX). This serial communication is channeled through USB by an ATmega16U2 on the board, which appears to software on the PC as a virtual com port.
Comments
Post a Comment