Posts

WEEK 17 REPORT

Image
For this week, the presentation day for FYP2 was held on 2 June 2021. The assessor for my project was Mr. Ahmad Zuber Conclusion from the presentation: The assessor suggest that for the further research, the prototype need to have the alert system to alert the biomedical personnel if there is the exceeding reading for the temperature and humidity in the imaging room The assessor also suggest that to have the backup plan if there is suddenly power trip in the imaging room and find out the way on how to solve the problem 

WEEK 16 REPORT

Image
For this week, the preparation for the FYP2 presentation was made, by preparing the slide presentation, video demonstration and also video presentation The figure above shows the first slide of slide presentation of this project The figure above shows the image from the video for demonstration  The figure above shows the image from the video for presentation 

WEEK 15 REPORT

Image
For this week, the meeting was conducted with the sv to update the progress of the project The figure above show the date and times of the meeting for the progress update Conclusion from the meeting: Need to overlook the problem related the project Need to collect the data to determined the project will success or not Ask the senior regarding the Lora module

WEEK 14 REPORT

Image
For this week, the data is collected in the simulation room. The data is collected to check on how far the lora can transmit and receive the data.  The figure above shows the transmitter circuit has been place in the simulation room The figure above shows the receiver circuit has been place outside the simulation room The figure above shows that data collected at 12:03 pm The figure above shows that data collected at 3:43 pm Analysis: In the simulation room, the distance that the lora took to transmit and receive data was about 5 meters The temperature and humidity was determined by the temperature and humidity of the air-conditioner There was a lot of disturbance that might be reasons the data being interrupted and cannot receive well, the serial monitor of Arduino IDE need to be on/off for few times to get the reading

WEEK 13 REPORT

Image
For this week, the data is collected at the open space place. The data is collected to check on how far the lora can transmit and receive the data. The figure shows the transmitter circuit has been place in front of the UniKL BMI field The figure shows the receiver circuit has been place in the student lounge The figure above show the reading is taken at 3:00 pm The figure above show the reading is taken at 4:01 pm Analysis: At open space, the distance that the lora took to transmit and receive data was about 60 meters The temperature and humidity was determined by the weather and there was no changes in an hour There was several disturbance that might be reasons the data being interrupted at 4:00 pm

WEEK 12 REPORT

Image
  For this week, for the transmitter circuit, the Lora module is been soldered with the headless pin, to make it easy to connect the Lora with jumper wire. After that, it was connected with Arduino uno and DHT11 to make it a complete circuit   The figure above show the transmitter circuit that has been constructed without the breadboard

WEEK 11 REPORT

Image
For this week, for the receiver circuit, the Lora module is been soldered with the headless pin, to make it easy to connect the Lora with jumper wire. After that, it was connected with Arduino uno to make it a complete circuit   The figure above show the receiver circuit that has been constructed without the breadboard