WEEK 14 REPORT
For this week, the data is collected in the simulation room. The data is collected to check on how far the lora can transmit and receive the data.
The figure above shows the receiver circuit has been place outside the simulation room
The figure above shows that data collected at 3:43 pm
Analysis:
- In the simulation room, the distance that the lora took to transmit and receive data was about 5 meters
- The temperature and humidity was determined by the temperature and humidity of the air-conditioner
- There was a lot of disturbance that might be reasons the data being interrupted and cannot receive well, the serial monitor of Arduino IDE need to be on/off for few times to get the reading
Comments
Post a Comment