WEEK 1 REPORT
For this week, the circuit that will be used in the project is being
designed. There will be two circuit required for the monitoring system, which
are transmitter circuit, that consists of Arduino Uno, Lora module (SX1278),
and DHT11 (temperature and humidity sensor) and receiver circuit that consist
of Arduino Uno and Lora module (SX1278)
The
figure shows the transmitter circuit for the project
The figure shows the receiver circuit for the project
Based on the research, the voltage required for both
of the circuit is 5V. For the transmitter circuit, it can use the portable
power supply, such as power bank, because power bank supply 5V/2.1A and 5V/1A.
The Lora module cannot afford the 5V supply because it will make the board
damaged. The VCC pin of the Lora module will be connected to the 3.3V pin on
the Arduino uno. The receiver circuit will be connected to the computer, to get
the reading.
Comments
Post a Comment